ISOTHERMAL COINPOL

Experience

COINPOL, S.A. (Industrial Constructions of Polyester, SA) with presence in Madrid since 1970 and registered office in Ctra. Villaviciosa-Pinto Km 16 -28 946 Fuenlabrada, has an experience of over 45 years in the transformation and conditioning of vehicles for transporting perishable goods.

Read more

Innovation

Since 1970 and according to regulations, a divider wall used to be installed, which separated the cabin cargo compartment, coating the entire cargo compartment with fiberglass reinforced polyester to prevent corrosion and contact of the sheet/veneer with the transported goods.

Read more

The team

COINPOL, SA not only has technical means of art, but also and above all a team of qualified, motivated and experienced in the sector.

Read more

We manufacture isothermal vehicles

Approved by the Ministry of Industry and Energy for the transport of perishable goods (ATP). Made of polyester resin registered and licensed by the Ministry of Health for use in Food Industry.
Thermal insulation using paneling model systems, kits and rough; as finish vehicle finish (depending on models).
Including doors and floor.

Know more about isotherms Vehicles

By moving different types of perishable foods, you should take into account the vehicle model that has been authorized for this purpose; the goal is not to break the cold chain because, if this happens, these products are no longer considered fit for consumption.

This is when isotherms become important vehicles; some vehicles are able to safeguard precisely this difference in temperature so they can get these foods to your destination without any problem occurs.

 

What are the isothermal vehicles?

 

Internally, an isothermal vehicle has been built with a special camera that will be able to maintain the temperature. The walls are insulated, which causes heat exchange that occurs between the exterior and interior be limited.

Within the range of transporting products, we find different vehicles: in addition to the “isothermal vehicles”, we also find those refrigerators that store temperatures between 30 and -20 and calorific that, unlike earlier, keep the temperature at about 12ºC average.

 

What must meet when transporting food in these vehicles? 

 

Debido a la importancia que tiene el hecho de mantener la cadena del frío existen una serie de medidas de seguridad y protocolos de actuación para aplicar en el caso de que algo pueda salir mal.

 

Here are some of the most important:

 

– The team of the vehicles isotherms or refrigerated vehicles must be started at least a half before they are to be introduced in these products carry. The aim of this is to pre cool this case to avoid problems. If introduced without cooling, although the space can be cooled relatively quickly a way, it would not be enough to ensure that they can consume without problems appeared.

 

– The ignition should last until occurred the last delivery of the order that has to be done.
– It is important to check at any time that the temperature of the vehicles isotherms be correct.

 

The problem of isothermal and refrigerated vehicles that exceed the recommended temperatures

The only way to ensure that products reach their destination without incident is opting for vehicles that do not depend same motor to get the right temperature. Maybe vehicles somewhat different from the usual, perhaps more expensive, but because of its effectiveness in achieving this transport, you should consider your purchase.

Request your quote